Dynamic Air Cleaner - Retro fits, SpaceGard air cleaner

Easy to install and hook up - only two low voltage wires

www.Dynamicaircleaners.com/video 

This system removes pollen, mold, dust mites, hairs pray, Cigarette Smoke,   bacteria, viruses, and things most system can't touch such as auto emissions, lead dust,  fine dust paint pigments, voc's odors off gases including formaldehyde from carpets furniture and cleaning products.

DYNAMIC AIR CLEANERS INSTALL QUICKLY WITHOUT COSTLY DUCTWORK RECONFIGURATION TURNING YOUR HOMES CENTRAL SYSTEM INOT A WHOLE HOUSE AIR CLEANER, WHILE SAVING YOU HUNDREDS OF DOLLARS VERSUS OTHER SYSTEMS.  RELIABLE PROVEN PERFORMANCE BACKED BY A SUPERIOR 5 YEAR WARRANTY

Combining ease of installation with low static pressure (for lower energy consumption and system wear), 1” Dynamic Air Cleaners are high-efficiency whole-house electronic air cleaners with an equivalency rating of MERV 13. As tiny sub-micron particles and volatile organic compounds (VOCs) pass through the central heating and cooling system, they become polarized. The polarized particles get larger as they join together with other polarized particles and collect on a disposable low-static polarized media pad with an activated carbon center screen. Dynamic

Air Cleaners remove difficult odors and provide an efficiency of 97.00% for particles down to .3 microns in size. 1” panels fit directly into existing filter racks or filter grilles and are powered using simple 24V wiring connected to the central HVAC system.

Installs quicky without costly duct work reconfiguration, turning your home cental system into a whole house air cleaner, while save you humdreds of dollars versus other system.  Very easy to wire only two low 24 v wires to hook up to furnace. it take  about 2 min to complete, my wife can wire this

What’s MERV?

MERV, or Minimum Efficiency Reporting Value, is a number from 1 to 16 that is relative to air filter efficiency. The higher the MERV value, the more efficient the air filter is at removing particles. At the lower end of the efficiency spectrum a fiberglass panel filter may achieve MERV 4 or 5. At the higher end, filters that achieve MERV 13 or 14 are typically used in hospitals and clean rooms. High MERV filters are capable of removing higher quantities of extremely small contaminant (particles as small as 1/300 the diameter of a human hair). Higher MERV ratings can create problems with greater airflow resistance. This is also referred to as static pressure. With most filters the filter media becomes denser, and static pressure increase, as the filter efficiency increases. Increased static pressure forces the system fan motor to work harder as it pushes air through the filter. This also increases energy consumption. So for optimum performance, consumers should select the highest efficiency filter with the lowest static pressure.

What’s a micron?

Particle size is usually measured in microns, a metric unit of measure. A micron is 1/25,000 of an inch. There are over 20 million particles in the average cubic foot of indoor air.

Approximately 98% of all particles (by count) are in the size range of 5 microns or less. Visible particles represent only a small fraction of particles found in indoor air.

5 Year warranty

For more infomation go to:   http://www.dynamicaqs.com/residential/